Reducing Crossover for 34mm/27mm Galvanised Pipe 27mm Galvanised or to attach kick-plates to

or to attach kick-plates to uprights

Plantation grown Radiata Pine that has been finger jointed and laminated for stability

The 171 clip can be used for attaching mesh panels to both sides of tube

The 199 Single Lugged Bracket is often used for mounting boards practically flush with tubes

The 242 Base flange is usually used for uprights on level sites with the addition of lugs for mounting toe boards

Reducing Crossover for 34mm/27mm Galvanised Pipe 27mm Galvanised or to attach kick-plates toWhere would you normally use this galvanised pipe fitting? The 161 reducing Crossover is designed to form a 90 degree crossover joint between two tubes, this fitting can reduce the need for cutting on horizontal rails. To add to existing structures, types 137 and 160 can often be used as alternatives. What size pipe does it fit to? This fitting will work with horizontal galvanised pipe (tube) of an outside diameter of approximately 34mm, and vertical