JTEKT-KOYO 2210-MG Self-Aligning Ball Bearing - 50 mm ID, 90 mm OD, 23 mm Width Yoke type track rollers 93 lbs table { width:

93 lbs table { width: 100%

regulation and safety functions

The 2-jaw and steering arm puller with hydraulic lift cylinder from series 129 is used for the hydraulic extraction of ball pins when removing ball joints on steering and tie rods specifically for trucks and low-floor buses

full-width-section li { margin-bottom: 5px

The hardened splitter edges ensure the splitting of nuts in a single operation

JTEKT-KOYO 2210-MG Self-Aligning Ball Bearing - 50 mm ID, 90 mm OD, 23 mm Width Yoke type track rollers 93 lbs table { width:Self Aligning Ball Bearing JTEKT KOYO self aligning ball bearings have two rows of balls and a common spherical outer raceway. They tolerate shaft and housing misalignment and accommodate moderate radial loads with low friction. They are ideal for applications where shaft deflection or mounting errors are expected.